 Did i kill it? |
|
|
|
|
Related links
Visit our LabVIEW Wiki Hardware Portal
Tags |
(This content has not been tagged yet)
|
 ·
 ·
 ·
 ·
 ·
 ·
 ·
 ·
 ·
 ·
 ·
 ·
 |
 Jul 23 2008, 12:15 PM
Post
#1
|
|||
|
4 more posts to go! Member Posts: 6 Joined: 18-July 08 Member No.: 12036 Using LabVIEW Since:2008 LV:8.20 ,. ,. 
 |
Hey!
My daq inputs dont show what i connect to them but 3of4 outputs work fine. i was using the output that isnt working anymore. but i only used one input but they are all gone. yesterday everything was fine and today... i was measuring my output yesterday with scope. could that have anything to do with it? Sorry to bother you with my adventures urh8 
|
||
 |
 
|
||
| Ad |
Jul 23 2008, 12:15 PM
Post
#
|
||
 |
|
||
|
|
|
||
|
Jul 23 2008, 04:30 PM
Post
#2
|
|||
 Extremely Active Member Posts: 509 Joined: 2-August 05 Member No.: 2680 Using LabVIEW Since:1996 LV:8.5.1 ,8.6 ,. 
|
Download a utility from the NI website that helps you run some diagnostics on your card.
In particular check the ground traces on the breakout board connected at the end of the cable from the DAQ card. If there is any damage, the breakout board will be the first to be affected. Reboot your PC, or power down, and put the DAQ card in another slot. Neville.
|
||
|
|
|
||
|
Jul 24 2008, 09:32 AM
Post
#3
|
|||
|
4 more posts to go! Member Posts: 6 Joined: 18-July 08 Member No.: 12036 Using LabVIEW Since:2008 LV:8.20 ,. ,.
|
I dont know what was wrong but after a few hours it was ok.
Its a mystery!!
|
||
|
|
|
||
|
| Time is now: 2nd December 2008 - 04:34 AM |